A simple, high quality, electric operated, aluminium roller garage door, specifically recommended when remote control operation is not necessary.
Using higher quality 55mm double skinned insulated slat sections, this is a compact roller garage door designed for single width garages up to 3m wide
Electrically operated using a 240V single phase internal tube motor with door control via a wall mounted control board with a very simple ‘Up’ and ‘Down’ button where the buttons are held for the duration of operation and therefore needs no beams or safety edge sensor system. Fully compliant and simple and easy to install and set up.
- 2 year Warranty as standard
- Suitable for inside face or inbetween opening installation
- 15 colours to choose from
- Made to Measure sizes as standard
NEW from GDO, this simple, high quality, electric aluminium roller garage door is designed for single width garages and when you are not bothered about remote controls and all the electronics that go with it. This roller door is best used where you have a separate access door to the garage or the garage is integral to the house so access to the internal control panel is guaranteed and also part of the daily routine perhaps when using the door for access.
A hold to run wall mounted control box gives you the door control internally and you can also have an external keyswitch for operating the door from outside if required (hard wired).
GDO insulated roller doors are manufactured in the UK by the leading garage door supplier SWS/ AlluGuard. Their decades of manufacturing experience ensure only the highest quality materials and production techniques are used, whilst the simplified design helps keep costs as competitive as possible.
Made to measure sizes up to a maximum ordering width of 3000mm including the guides either side.
Maximum height is 2225mm plus the height of the roll and endplates which is 205mm
Available in 3 very popular and striking colours with white guides and hood when ordered.
Optional 12 premium colour finshes at small surcharge.
The guides, ednplates and half hood or full hood are also finished in the same colour as you choose for the curtain when ordering.
This is the Full Hood cover version for this roller door where the complete enclosure of the curtain ensures the very best weather protection at all times.
The ‘half hood’ version of this roller door has a folded aluminium hood cover which forms a front facia when fitting behind or inbetween any opening to give a neat finish and better sealing when closed.The hood cover is fitted to the endplates on either side of the roller barrel which the curtain rolls around.
Domestic electric roller garage door for domestic use.
Simple locking strap for holding curtain closed.
The GDO ROLL 55 is constructed from high quality 55mm deep double skinned aluminium slats with a foam filled core. It is a made to measure, 240V, tube motor operated, electric roller garage door, manufactured to the exact millimetre in width and height.
The door is electrically operated as standard and incorporates an internal emergency manual release in case of a power failure. This is a winding process using a winding handle provided attaching via a hook to the eye of the motor drive. This can be specified as either on the left or right as viewed from inside the garage (same side as motor).
A wall mounted hard wired control panel has an impulse push button for opening the door, with a stop button to stop it at any point. For closing the door, the down button is pushed and held until the door closes fully.
The curtain of this door rolls around a steel barrel which is supported either side by steel endplates which have a dimension of 205mm x 205mm, which is the headroom required if you wish to hide the roll. Always allow for a maximum 50mm of curtain ‘hang down’ when the door is opened if the opening height is critical to you. This is the same on all roller garage doors.
The guide height as used for ordering does not included the endplate size above it and the loss of drive through height with the bottom slat hang down when open.
Door guides either side are 60mm wide and 34mm deep and the door is ordered using the ‘OVERGUIDE’ width from the curtain and guides combined. These newly updated guides feature brush seals making the door quieter and improve the seal against the weather.
The door can be fitted BEHIND or INBETWEEN the structural opening as required but always check you have order the correct dimensions to take into account the guides and endplates (full hood cover if ordered is the same dimensions)
Fitting Position
> Between the opening
> Behind the opening (for maximum width and height). This gives it the freedom to be fitted in the most complex locations regardless of the shape of the garage opening. Single and double garage door sizes are catered for meaning almost all requirements can be met. This makes it highly practical for owners of 4x4 vehicles or similar cars of a large nature who otherwise find problems driving into their garage. This installation style can be used to install the door externally, however, this will cause the motor handing and curtain to be reversed.
 |
 |
 |
 |
 |
| Hand crank | Lined guide | ZF Lock | Barrel | safety brake |
Optional Premium Colours:
Brown RAL 8014
Chartwell green
Navy Blue RAL 5011
Burgundy RAL 3004
Fir green RAL 6009
Ivory RAL 1015
Agate Grey RAL 7038
Silver Metallic RAL 9006
Dark brown RAL 8019
Moss Green RAL 6005
Cream White RAL 9001
Installation Instructions are provided with every door.
Below are some details for the external emergency manual override system which you can order if you don't have another entrance to your garage..
The emergency manual override always is on the same side as the electric motor drive and built into the electric motor..
Ordering sizes for the ROLL 55 are the Over Guide Width (OGW) x Guide Height (GH).
Doors have 60mm wide guides*
These measurements are correct for behind fit installations, please contact us for guidance inbetween fit installations.
Clear opening height = guide height - 50mm (to allow for the bottom slat hand-down into the guide). The 205mm endplates incorporating the motor and barrel are to be added onto the guide height to give your total height required (Overall Height)
Our Promise
We pride ourselves on our customer service and are always happy to help